maxmil982
Junior Member
It's the V6 with 6.5 fronts. I'd like to replace the 6.5s with crescendo pwx6 8" mids. Anyone have pics of a similar setup or advice/resource material on how to fabricate the doors to get these 8s to fit? Thanks in advance
Anything is possible I put Kicker Resolution 8s in my 84 S10 doors even though there's no spot for door speakers from the factory ...At least you have something to work with . Mine came out nice enough for meIt's the V6 with 6.5 fronts. I'd like to replace the 6.5s with crescendo pwx6 8" mids. Anyone have pics of a similar setup or advice/resource material on how to fabricate the doors to get these 8s to fit? Thanks in advance
Are you planning on doing a full sound treatment for the doors?
It can be some work if you seal up the door cavities, make a custom mounting baffle, and fiberglass your door card to fit it.
I'm in the middle of the glass work now and I'm finding it challenging with a busy work schedule, but it'll get done eventually.
I'm glassing my card to hold a ring that a grille will snap into.View attachment 19990
This is the baffle for it. It will get sprayed with bedliner before the final install.View attachment 19993
You basically have to decide if you are going to make door pods that essentially become a part of the door card OR you mount them in the main door and probably have to fab something for your door card because they will likely be sticking out too far.So assuming that baffle will bolt onto the door panel from the back side?
Can you send pic of a side view of the baffle and snap some pics along the way of the rest of your project? I'm totally new to audio fab and need to do a ton of research still and watch some how to vids, but I'm pretty confident I'll be able to do it. And yes I'll be doing a full door treatment.
If you post some pics of your door or any specific questions, I'll be happy to try and help if i can.It's the V6 with 6.5 fronts. I'd like to replace the 6.5s with crescendo pwx6 8" mids. Anyone have pics of a similar setup or advice/resource material on how to fabricate the doors to get these 8s to fit? Thanks in advance