Recent content by Doxquzme

DId you use grommets? IS it possible that the water is riding on the outside of the cable into the trunk? Which power fuse and where it is it?

Which Skar LOC, which SPL Audio amp and which Skar sub(s)?

I believe that the LC2i has a fixed subsonic filter at 33hz, that will affect the low end too. THe LCi2 pro has a set filter at 22 hz, better. What specific amp and what specific woofer?

Here is the user manual https://www.samodelka.ru/pictures/data/f4.pdf

Sorry, was not aware that a pair of full range speakers was in the plan so yes, you can use it for a pair of full range speakers and a sub, that would work just fine.. If you are using it with a pair if regular speakers, AND a sub, then you would end up with 133 x 2 to a pair of 4 ohm full...

I would not opt for the inexpensive Focal's (and I've used/use currently - their products extensively in both car and HT applications) and while a fan of Audiocontrol products, have not used any of their speakers and would wager they are build house units with their logo on them. CDT has a...

Generally speaker-ing, when mixing types, your A/B amps are used for mains. Class D is much more efficient. Since you are starting off with a 4 ohm sub and a single voice coil, not really a compatible mix with what you have. 330 watts x2 would have been fine with a dual vc sub, not the case...

My brain hurts just looking at those diagrams. It's late so if anyone sees a problem with either of those, please feel free to chime in!

- OR- -

Geez, my brain hurts. It's a series parallel configuration. You will need to run a 4x4 and parallel the two groups. 2 groups of 4 woofer series/parpelle like this then the two groups in parallel should get you to 1 ohms.

That is a four channel class A/B amplifier that if bridged to 2 channels it puts out approximately 330 watts x 2. The problem is that your sub is a single voice coil. That amp is really not designed to be used in this application, more four all for corners of a car where is puts out 4x100 at...

The Sakr OFC wire is as good as any other for that price for sure, not talking about their amplifiers. If you have enough, dual 12 gauge runs are equal to 9 AWG, 3 parallel runs are equal to 7 and 4 parallel runs are equal to 6. Doubling up should be fine. This stuff is pretty reasonable too...

So, assuming that you aren't using an LOC and are using the hi-level (speaker) inputs, use the speaker leads off of any of the R/L speakers (front or rears) in the car. It is important to use both R/L leads from a pair of R/L speakers so the sub amp can sum the signals from both sides of the...

Remind me of the configuration again. HU speakers output to the Kicker LOC? Which sub and what amplifier for the sub?

These are also very good drivers, some of the best bang for the busk on shallow mounts. DD Audio SL610-D2 10" https://www.amazon.com/dp/B0BMWPT5S2/?tag=caraudiocom-20 Speaker Size (In): 10 Watts RMS: 600 Watts Peak: 1800 Impedance: D2 / D4 VCD (In): 2.5 Piston Diameter (In): 8.32...